Australian Slot Car Racers Association

Posted: **Fri Aug 05, 2016 11:48 am**

Well the weather has been perfect for chassis building the last week with nothing but rain so I decided to build a new Can Am Chassis for the HSC Flat Track.

Over the years the 0.078" rail Warmack Kit configuration has been really fast around this track so I decided to follow suit and try to emulate the weight spread using 16# brass plate.

Here she is:-
0.078" rails
Chicago-land (Mike Swiss) nose piece
16# brass plate
JK Hypoid Bracket

: 1-IMG_5438.JPG (91.09 KiB) Viewed 6111 times

: 2-IMG_5439.JPG (111.66 KiB) Viewed 6111 times

: 3-IMG_5440.JPG (92.82 KiB) Viewed 6111 times

: 4-IMG_5441.JPG (86.39 KiB) Viewed 6111 times

: 5-IMG_5442.JPG (78.57 KiB) Viewed 6111 times

: 6-IMG_5443.JPG (106.63 KiB) Viewed 6111 times

: 7-IMG_5444.JPG (106.77 KiB) Viewed 6111 times

It is still probably a little light for the track but I will be taking it up to HSC tomorrow to try and get it fit for the nights' round of the club championship.

: 8-IMG_5445.JPG (78.18 KiB) Viewed 6111 times

Posted: **Sun Aug 07, 2016 6:18 pm**

I think I got it pretty right.

New car on track and it is a real gem - no added weight - goes great.

The track was not optimal as James had no time to clean it and I only had an old Cheetah 2 installed - however the times done by my new car were very good in the race and I believe the upside is still considerable

: 3-img481.jpg (17.58 KiB) Viewed 6088 times

Posted: **Mon Aug 08, 2016 10:41 am**

Posted: **Mon Aug 08, 2016 11:15 am**

Thanks for sharing. The Warmack looks very nice as well.

Australian Slot Car Racers Association

New CanAm for HSC Flat Track

New CanAm for HSC Flat Track

Re: New CanAm for HSC Flat Track

Re: New CanAm for HSC Flat Track

Re: New CanAm for HSC Flat Track